Project EXI

The building of a Marlin 5EXi kit car, using a Seat Leon 1.8T 20v Donor
Main > Archives > 2010 > 08 >
< 00:00:00 >

Aug 15 2010

Radiator Mounts completed, Horn fitted, instruments connected

180-IntercoolerRadiatorMounting/IMG_5636.jpg

Again another busy weekend.
- Finished paint and prep on intercooler/raditor mounts.
- Fitted radiator and intercooler into A-Frame,
- Fixed radiator pipes through tunnel with 6x 35mm pipe clips, had to make hole in front bulkhead slighty bigger. Two clips on rear bulkhead, two on front bulkhead and two on tunnel cross member with spacers in front of gear change mount.
- Extended MAF sensor wiring and covered in wiring pipe.
- Fitted Boost pressure sensor into small lenght of 57mm pipe, and connected in line to throttle in take housing.
- Fitted Header tank and replaced feed hose with 15mm heater hose.
- Fitted horn to front bulkhead, and connected wiring to terminals.
- Fitted brake level wiring to reservouir
- Fitted Adjustable thermostat control wires to thermostat and radiator fan.
- Fitted 6 way instrument warning panel to wiring loom, ready for first electrical power on.


Posted by Steve | Permanent link | File under: heating and cooling